I am still unable to make it work, the steps I am doing
I connect 4 wires, 3.3v, Gnd Tx and Rx (nrst i leave floating)
With Sercomm I am able to set AT+DEBUG=2 (is this correct?) to use the protocol described at Radar LD6001A-60G Protocol Specification DocumentV 1.1
But after that I am unable to request anything to the sensor with that protocol
If I send a query like this 44110000554B the result is AT+ERR because the sensor is till at AT mode. How do I stop AT mode and start the protocol communication.
Also the 60G.exe doesnt show anything after I connect and isuue a start